| |
| Remove the top of the three pedals by removing the two screws from each pedal. |
 |
| Open the pedals by unscrewing the screws in the photo. |
|
| Once the top cover is removed, you have access to the pedals. |
 |
| Remove the two upper bolts from the brake cylinder. |
 |
| Remove the upper part and the spring, if they are the G29 pedals, also remove the white part of the lower cylinder and the rubber pad (these parts are not going to be used), that rubber pad is extremely hard and of little use, in fact in the G923 pedals that rubber block has been eliminated.. |
 |
| Insert the elastometer into the three grooves of the lower cylinder. |
 |
| Put the spring, the elastomer is not screwed into the spring, it remains inside the spring. |
 |
| Put the upper cylinder and replace the two screws of the upper cylinder. |
|
| Screw the cap back on to close the pedals and fit the pedal plates. |
| |
